Influence of seawater on the strength of RC beams and corrosion behavior of steel
College
Gokongwei College of Engineering
Department/Unit
Civil Engineering
Document Type
Article
Source Title
International Journal of GEOMATE
Volume
14
Issue
42
First Page
58
Last Page
64
Publication Date
1-1-2018
Abstract
The effects of seawater on the strength performance of reinforced concrete (RC) beams were investigated. Four RC beams measuring 150 × 200 × 800 mm were constructed. Two beams were constructed with concrete mixed with freshwater and the other two were constructed with seawater. Center point loading test was conducted on the beams specimens. Load, deflection, and strain of each beam were monitored and recorded. It was found that the difference between the strength test values obtained by using freshwater and seawater were minimal. However, formation of rust in steel when seawater was used was very evident. Hence, the effects of seawater on the corrosion behavior of steel were investigated. Mortar specimens with cold-joint were used as medium to facilitate the investigation of corrosion. Ordinary Portland cement (OPC) Type 1 was used as binder for the mortar and was partially replaced with fly ash at 30% and 50%. Rectangular prism specimens of dimensions 40mm by 40mm by 160mm were cast for macrocell corrosion measurements and compressive strength determination. From the test results, the following were observed: (a) Specimens with fly ash were observed to have lower corrosion rates compared with the ones without fly ash; (b) Specimens mixed with freshwater resulted to the higher strength both at 7th-day age and 28th-day age; (c) Regardless of the type of water used in making the mortar, specimens cured in seawater achieved higher later strength values. © Int. J. of GEOMATE.
html
Digitial Object Identifier (DOI)
10.21660/2018.42.7158
Recommended Citation
Lejano, B. A., & Roxas, C. C. (2018). Influence of seawater on the strength of RC beams and corrosion behavior of steel. International Journal of GEOMATE, 14 (42), 58-64. https://doi.org/10.21660/2018.42.7158
Disciplines
Civil Engineering
Keywords
Seawater corrosion; Concrete beams—Corrosion; Concrete beams—Testing; Fly ash
Upload File
wf_no